Advertising
•Installation •Operation •Maintenance
Atwood energized this product line by developing the Ultra Breeze Vent Cover, EZ-Breeze vent, and modernized controls. In 2014 Dometic purchased Atwood Mobile Products to complement and bolster Dometic's robust product line. Atwood is now sold under the Dometic brand, and the product assortment can be found in the following categories. If water heater is installed where leakage of connections or tank will damage adjacent area, install a drain pan which can be drained to out side of coach, under water heater. Connect both 1/2' NPT water lines - hot water outlet female (FIG I-A) and cold water inlet female (FIG 1 -B) and 3/8' flared LP gas lines (FIG 1 -C). Mar 30, 2017 Atwood Water Heater Prior to turning on your water heater, make sure it is full of water by turning on the hot water side of a faucet. When it stops spitting and sputtering it is full. The RV Water Heater. There are basically two manufacturers of RV water heaters that are used in todays RVs - Atwood and Suburban. The Atwood uses an aluminum water tank while the Suburban brand uses a glass lined steel water tank. Maintenance and servicing procedures are similar to both models. Had hot water yesterday - none today. Tagalong trailer is using an Atwood GC6AA-10E water heater, 6 gallon, auto-ignition for the gas side. Was running it on electric only yesterday. Worked like a champ. This morning, no hot water. Turned on the gas side in addition to the 120v electric. No hot water.
Effective 5/8/2012
Atwood Hot Water Heater User Manual Lx Manual
LITERATURE NUMBER
MPD 90307
Cold Weather Kit #90290
for On Demand Water Heater Models
OD4501 and OD5001
OD4501 and OD5001
Cold Weather Kit Installation
1) Installation requires the disconnection of the
water lines, gas line, and electrical connections
in the rear of the unit and removal of the unit
from the RV to a bench.
2) First remove the upper tri-panel by removing
(25) screws, unplugging the pressure switch,
ignition control, relay and blower connection,
and lifting off the case, exposing the interior
components.
1) Installation requires the disconnection of the
water lines, gas line, and electrical connections
in the rear of the unit and removal of the unit
from the RV to a bench.
2) First remove the upper tri-panel by removing
(25) screws, unplugging the pressure switch,
ignition control, relay and blower connection,
and lifting off the case, exposing the interior
components.
3)Next lay out the harness with the ground
eyelet at the grounding point with the existing
ground eyelet, the first and second ceramic at the
locations indicated, the pad behind the
modulation valve, and the thermostat close to the
inlet tube grommet.
eyelet at the grounding point with the existing
ground eyelet, the first and second ceramic at the
locations indicated, the pad behind the
modulation valve, and the thermostat close to the
inlet tube grommet.
Kit Includes:
Samsung tablet user manual downloads. - Heater Assembly # 90296
o
Ceramic Clips (2)
o
Heater assembly
o
Tie Wraps (2 Long, 4 Short)
- Insulation Tape (36”) (Note: must be cut
Vaillant ecotec pro 28 user manual download. into 16”, 14” and 4” pieces)
- Instruction
This kit includes the components necessary to
provide protection of the lower extremities of the
water circuit from freezing.
Protection of the heat exchanger (control of the
burner) is accomplished with a low temperature
thermostat which was provided standard on the
unit. It will provide protection for the heat
exchanger to ambient temperatures as low as 15°
F.
This kit is for adding protection of the lower
extremities i.e. the water tubes and the
modulation valve. It operates automatically
when the internal water temperature drops to
38°F.
Thermostat Replacement: (Part must be
ordered separately, # 90311)This switch is
used to light the burner for a limited ignition
cycle of the burner when temperatures dip to and
below approximately 40° F. It is only effective
when the power (12 vdc) is on and the LP tanks
are not turned off during travel or storage. If
there is continuity (switch closed) when the
ambient temperature is above 60° F, it is faulty
and requires replacement.
Advertising
Popular Brands
Popular manuals
03-14-2016, 02:23 PM
Atwood Hot Water Heater User Manual Download
Had hot water yesterday -- none today.
Tagalong trailer is using an Atwood GC6AA-10E water heater, 6 gallon, auto-ignition for the gas side.
Was running it on electric only yesterday. Worked like a champ. This morning, no hot water. Turned on the gas side in addition to the 120v electric. No hot water.
No blown fuses and no issue with water pressure from the hot water lines (city connection). Gas is on and operating (had to run the furnace this morning).
No reset buttons on this Atwood model that I can find in either the user manual or on the unit itself.
Suggestions?
Tagalong trailer is using an Atwood GC6AA-10E water heater, 6 gallon, auto-ignition for the gas side.
Was running it on electric only yesterday. Worked like a champ. This morning, no hot water. Turned on the gas side in addition to the 120v electric. No hot water.
No blown fuses and no issue with water pressure from the hot water lines (city connection). Gas is on and operating (had to run the furnace this morning).
No reset buttons on this Atwood model that I can find in either the user manual or on the unit itself.
Suggestions?